• Account
  • View Shopping Cart

Menu Search View Shopping Cart Call Us

DPA ST2011A Stereo Pair with 2011A Cardioids Demo/Open Box  From DPA (B&K)

Impeccable transient detail, low noise, and tonal transparency! The DPA ST2011A is a complete DPA 2011A Stereo Pair with two handpicked cardioid microphones, selected on sensitivity within ±1.5 dB making several stereo principles like XY and ORTF easy to obtain.

DPA Microphones (Bruel & Kjaer)

SDC Mic Shootout on Acoustic Guitar: M60 vs. 2011A vs. P84 vs. C42

In this video comparison, we put four small diaphragm condenser microphones to the test, as we demonstrate the TELEFUNKEN Elektroakustik M60, the DPA 2011A, the Josephson C42, and the Peluso P84. Can you tell which one's which?

Manufacturer's Description from DPA (B&K)

Finding its use on numerous stages and recording sessions, the ST2011A exhibits a previously unheard blend of clarity, richness and dynamic range, the 2011As perform close to much more exclusive microphone pairs.
 
The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone/accessory inlays.
 
Included in this kit:
Two carefully matched 2011A cardioid microphones, sturdy PeliTM case, holders, and windscreens.
DPA Microphones (Bruel & Kjaer)

About Manufacturer

DPA Microphones A/S is a leading manufacturer of high quality condenser microphones and microphone solutions for professional applications in studio, broadcast, theatre, video/film, houses of worship, teleconference and sound reinforcement environments.

Specifications

Directional pattern: Cardioid
Principle of operation: Pressure gradient, with interference tube
Cartridge type: Pre-polarized condenser, Twin Diaphragm Capsule
Frequency range: 20 Hz - 20 kHz
Frequency range, ± 2 dB, at 30 cm: 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz
Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 33 dB (max. 36 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 74 dB(A)
Total Harmonic Distortion (THD) at 1 kHz: < 1 % up to 137 dB SPL peak
Dynamic range: Typ. 117 dB
Max. SPL, peak before clipping: 153 dB
Switchable attenuator: 0 dB / -20 dB
Output impedance: < 200 ohm
Minimum load impedance: 2 kohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): > 60 dB
Power supply (for full specifications): 48 V Phantom power (± 4 V)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color: Matte black
Weight: 164 g (5.8 oz)
Microphone diameter: 19 mm (0.75 in)
Microphone length: 198 mm (7.8 in)
Output voltage, RMS: > 5 V
Polarity: +V at pin 2 for positive sound pressure
Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
Relative Humidity (RH): Up to 90%
Sensitivity selection tolerance (at 1 kHz): ± 1.5 dB